Last updated on June 14, 2016
These are the instructions to root Samsung Galaxy S6 Edge SM-G925S (running on android 6.0.1, built id MMB29K.G925SKSU3DPAC) using Odin on Windows Computer.
Requirements: Your Samsung Galaxy S6 Edge SM-G925S should have atleast 30-40 percent of battery to perform the rooting process.
Root Samsung Galaxy S6 Edge SM-G925S
Step 1: Download and Install Samsung USB Driver on your computer. If you have already installed the drivers on your computer then Skip this Step.
Step 2: Download and extract the root files on your computer. After extracting you will be able to see the following files:
Step 3: Now, Switch off your Smartphone.
Step 4: After switching-off the phone, you need to boot into Download Mode. To boot into download mode Press and hold Volume Down, Home and Power button at same time for 5-8 seconds until download mode is active.
Step 5: In the Download mode you will be able to see a Warning Yellow Triangle Sign. In this situation you have to press the Volume Up key to continue.
Step 6: Now, Open Odin3 (found in the extracted files, that you have downloaded in the Step#2) on your computer. Then connect your Smartphone to the computer.
Step 7: Once you have connected the Smartphone to the computer, Odin will automatically recognize the device and show “Added” message at the lower-left panel.
Step 8: After getting the device detected by Odin, click on the PDA button and select the CF-Auto-Root.tar file.
Step 9: Now, click on the Start button in Odin to begin the Flashing.
Step 10: Flashing usually takes 30-50 seconds to complete the rooting process on your Samsung Galaxy S6 Edge SM-G925S. Once Rooting process is completed you will be able to see a Green Box with Pass written on it in Odin. During this process Smartphone will re-boot automatically.
Step 11: Once you see, the Pass message in Odin, you can disconnect your Device from the computer.
Step 12: Now, to make sure you have successfully rooted your Samsung Galaxy S6 Edge SM-G925S, open Applications Menu on your Smartphone and Find SuperSU App. If this app exist on your Smartphone then it means you have successfully rooted your device. Congratulations.
Optional: You can also verify that your device is successfully rooted or not by Root Checker Application.
Keep in Mind:
[*] Warning: The above tutorial is only for Android 6.0.1 with the built id MMB29K.G925SKSU3DPAC.
[*] If your device isnt running on the same built id MMB29K.G925SKSU3DPAC, then you need to download and flash the firmware based on the same build id then after try to root your device from the above method.
[*] No data loss process: Your Smartphone Data like contacts, pictures, videos, music and etc will be not affected with this method. In short, no data loss process.
[*] Samsung Stock Firmware: If you are looking for the original firmware for your device then head over to Download Samsung Stock Firmware for all devices page.
[*] Samsung USB Driver: If you are looking for the original USB Driver for your device then head over to Download Samsung USB Driver for all devices page.
[*] Big thanks to Chainfire for their CF Auto Root file for Samsung Galaxy S6 Edge SM-G925S, without this tool this tutorial was not possible.