Updated on September 20, 2018
These are the instructions to remove or bypass the Comio C1 FRP protection using the SP Flash Tool on Windows Computer.
Requirements: Your device needs to have at-least 30-40 percent of battery to perform the flashing process.
Remove Comio C1 FRP using SP Flash Tool
Step 1: Download and install CDC Driver on your Computer. If in case CDC or VCOM drivers are already installed on your computer then SKIP this step.
Step 2: Power Off your Device.
Step 3: Download and Extract the Comio C1 FRP Remove File on your computer. After Extracting the Comio C1 FRP File, you will be able to see the following files:
Step 4: Download and Extract the latest version of SP Flash Tool on your Computer. After Extracting the SP Flash Tool on your Computer, you will be able to see the following files:
Step 5: Now, Open Flash_Tool.exe.
Advertisement
Step 6: Once SP Flash Tool is Launched, Click on the Download Tab to Proceed.
Step 7: Now, Click on the Download Agent Choose button and Select the Comio_C1_DA.bin (found in the FRP Files Folder).
Step 8: Now, Click on the Scatter Loading Button and Load the Comio C1 Scatter File (found in the extracted file in Step#3).
Step 9: Now, Click on the Format Menu.
Step 10: Under Format Menu, select Manual Format Flash.
Step 11: Now, Set the Following parameters: Region: EMMC_USER, Begin Address[HEX]: 0x6a00000, Format Length[HEX]: 0x100000.
Step 12: Now, Click on the Start Button:
Step 13: Now, Connect your Device to the Computer using the USB Cable (make sure device is Power Off). After connecting the device to the computer, Press Volume Down and Up Keys on your Smartphone to get it detected by the SP Flash Tool.
Step 14: Once SP Flash Tool is able to detect the device, flashing process will start automatically and May take upto 5 minutes to get it completed.
Step 15: Once Flashing process is completed, you will be able to see the Green Tick at the End.
Step 16: Now, Close the SP Flash Tool and Disconnect your device from the computer.
Step 17: Restart your device.
Readme Once:
[*] Why Flashing is Not Starting: Flashing process will only begin if you have successfully installed the Android CDC Driver or Android VCOM Driver on your computer. And If in case Drivers are already installed, you need to press the Volume keys after connecting the device to the computer.
[*] Alternative Tool: SP Multiport Download Tool is the alternative Flash Tool which can also be used for Flashing the Scatter File. But we always recommend you to use SP Flash Tool against SP Multiport Download Tool.
[*] Credits: The FRP file shared above is submitted by our reader Gsm Abdullah. So, full credits goes to him for sharing the File for free.